The Efficiency of Voltage Stabilizer Installation in Addressing Power Quality Issues through Analysis Using an Injection Power Analyzer in the Manufacturing Industry of PT XYZ
DOI:
https://doi.org/10.62146/ijecbe.v4i1.173Keywords:
Power Quality, electronics devices and power analyzerAbstract
In today's modern era, electrical energy has become a vital secondary need for society and serves as a key foundation for economic development. Along with the rapid advancement of complex electronic devices, various power quality disturbances have emerged, negatively impacting industrial equipment such as active line modules and motor drivers, potentially disrupting production processes. A similar issue occurred at PT XYZ, prompting real-time power quality monitoring using a power analyzer installed on the LVMDB panel. This device can record and analyze power quality trends visually. Based on the data, PT XYZ took corrective actions, including adjusting the tap changer position from 3 to 1 and installing a voltage stabilizer, which effectively stabilized the voltage supplied to production machines. Furthermore, a harmonic analysis simulation showed a Total Harmonic Distortion of 8,35% for current and 7,92% for voltage. After applying a power filter design in ETAP, these values significantly decreased to 1.98% (current) and 2.08% (voltage). Based on these findings, it is recommended that PT XYZ proceed with the installation of a power filter to comprehensively improve power quality.
References
Prasetyo, H. (2020). Analisis Kualitas Daya Listrik pada Industri Menggunakan Power Quality Analyzer. *Jurnal Teknik dan Sains*, 8(1), 45–52.
Yacamini R., “Power system harmonics. II. Measurements and calculations” IEEE Power Engineering Journal, vol. 9, (1995): pp. 51-56. DOI: https://doi.org/10.1049/pe:19950113
Widodo, A., & Sudibyo, S. (2014). Analisis Gangguan Harmonik pada Sistem Tenaga Listrik dan Upaya Penanggulangannya. *Jurnal Teknik Elektro*, Universitas Diponegoro.
D. Sharon, “Power Quality Factor for Networks Supplying Unbalanced Nonlinear Loads,” IEEE Transactions on Instrumentation and Measurement, vol. 57, no. 6, pp. 1194–1201, Jun. 2008. DOI: https://doi.org/10.1109/TIM.2007.915146
H. Akagi, “New trends in active filters for power conditioning,” IEEE Trans. Ind. Appl., vol. 32, no. 6, pp. 1312–1322, 1996. DOI: https://doi.org/10.1109/28.556633
Nugroho, D. W. (2019). Perbaikan Faktor Daya dan Reduksi Harmonik Menggunakan Filter Pasif. *Prosiding Seminar Nasional Teknik Elektro – Universitas Gadjah Mada*.
Mendalek N., Al-Haddad K., Fnaiech F and Dessaint L.A., “Nonlinear control technique to enhance dynamic performance of a shunt active power filter” IEEE Trans. Power application, vol. 150, (2003):pp. 373–379 DOI: https://doi.org/10.1049/ip epa:20030488
Arifin, R. (2018). Studi Total Harmonic Distortion (THD) pada Sistem Distribusi Listrik Industri Menggunakan Power Quality Analyzer. *Jurnal Teknologi dan Sistem Informasi*, 6(1), 22–29.
Suwarno. (2011). *Kualitas Daya Listrik: Konsep dan Aplikasi*. Bandung: Penerbit ITB.
Maulana, R., & Iskandar, A. (2019). Perancangan Voltage Stabilizer Berbasis Relay Otomatis untuk Menjaga Stabilitas Tegangan Listrik. *Prosiding Seminar Nasional Teknologi dan Rekayasa*, Universitas Muhammadiyah Purwokerto.
Prasetyo, H. (2020). Analisis Kinerja Voltage Stabilizer pada Sistem Distribusi Listrik Industri. *Jurnal Rekayasa Elektro dan Energi Terbarukan*, 2(1), 35–42.
Suwarno. (2011). *Dasar-Dasar Teknik Tegangan Tinggi dan Transformator*. Bandung: Penerbit ITB.
Ardiansyah, T. (2018). Studi Pengaturan Tap Changer pada Transformator Distribusi untuk Menjaga Kestabilan Tegangan Beban. *Jurnal Energi dan Kelistrikan*, 6(1), 33–40.
Tareq Foqha et al., A New Iterative Approach for Designing Passive Harmonic Filters for Variable Frequency Drives. (2023). Menampilkan konfigurasi STPF dan menjelaskan fungsi komponennya R, L, C untuk menarget harmonisa dominan. DOI: https://doi.org/10.18576/amis/170307
Frontiers in Energy Research. (2022). Design and modeling of a passive power filter. Artikel ini mengulas berbagai tipe filter pasif (single-tuned, double-tuned, high-pass), dengan penekanan pada penggunaan HPF untuk meredam harmonisa orde tinggi (11, 13, 23, 25). DOI: https://doi.org/10.3389/fenrg.2022.989857
Sher, H. A., & Eltamaly, A. M. (2011). Harmonics reduction techniques – A survey. *International Review on Modelling and Simulations*, 4(6), 3135–3147.
Turunen, J. (2009). *Series active power filter in power conditioning* [Tesis]. Institusi atau Universitas tempat tesis diselesaikan.
G. J. Wakileh, Power Systems Harmonics: Fundamentals, Analysis and Filter Design, Springer, 2001. DOI : https://doi.org/10.1007/978-3-662-04343-1
S. R. Moorthi, Power Electronics: Devices, Circuits, and Applications, Pearson, 2018.
Chapman, D. (2014). Harmonics – Causes, Effects, and Solutions. Schneider Electric White Paper.
Ramasamy, M. R., & Kannan, S. (2013). Simulation of active power filter using ETAP. *International Journal of Engineering and Technology (IJET)*, 10, halaman‑halaman.
L. Gyugyi, “Reactive power compensation using static VAR compensators,” IEEE Power Eng. Rev., vol. 9, no. 1, pp. 15–20, 1989. DOI: https://doi.org/10.1109/5.4433
Hosseini, S. H. (2010). Voltage Quality Improvement Using a Combined System of DVR and D‑STATCOM. *IEEE Transactions on Power Delivery*, 25(3), hlm
Abdel-Galil, T. K. et al., "Unbalanced Loads and Voltage Imbalance in Power Systems", IEEE Transactions, 2016. DOI: 10.1109/ICPEICES.2016.7853717
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2026 International Journal of Electrical, Computer, and Biomedical Engineering
This work is licensed under a Creative Commons Attribution 4.0 International License.
